Bottom mounting variant - classic retrofit installationbr/>For AL-KO chassis without the stamped "M" on the longitudinal frame and chassis from other manufacturers.
AL-KO MAMMUT is bolted to the frame by means of a crossmember underneath. The ground clearance is reduced by the height of the cross brace (approx. 50 mm). In this installation variant, installation is possible either in front of or behind the axle.
Easy installation:Both drives screwed to the frame via the cross strut, plus-minus cable connected to the battery, magnetic switch mounted on the drawbar - done!
Perfect one-hand operation via joystickWith no effort at all and only one hand, you can move the vehicle to the desired position with the hand-held radio transmitter. The joystick reacts sensitively and smoothly to the operator's command. Where the thumb points, the caravan also moves. The joystick willingly follows all movements of your thumb in all directions and in any speed you desire, infinitely variable and with a sensitivity that will inspire you.
High performance and safeClimbing ability depending on the condition of the ground maximum 28%. Immediate stop on slopes: As soon as the joystick is released, the trailer stops on the slope, braked.
Safety first: Activation and automatic switch-off
Operation is only possible if the hand-held radio transmitter is activated at the overrun device. This prevents operation in a passenger car while driving (child safety lock).
Max. permissible total weight: 2.25 t single axle and tandem axle
Max. permissible total weight: 2.25 t single axle and tandem axle
Max. permissible total weight: 2.25 t single axle and tandem axle
Max. permissible total weight: 2.25 t single axle and tandem axle
Max. permissible total weight: 2.25 t single axle and tandem axle
Max. permissible total weight: 2.25 t single axle. Gradeability:
For a total weight of 2.25 t: 13%
For a total weight of 1.80 t: 16%
For a total weight of 1.20 t: 28%
With Softstart and Softstopp
In the direction of travel in front of the axle and behind the axle is possible.
The standard kit for bottom mountingcan be used with AL-Ko and third-party chassis under the following conditions: The frame height X must be at least 185mm (measured in the installation area, optionally in front of or behind the axle). The frame profile must be a U or C profile and have a material thickness of 2.5 to 3.5 mm.
Additional kits can be found under article no. 920922 (reinforcing plates with screw material), 920923 (spacer plates with screw material), 920924 (special cross strut with Mammut holder).
